Panasonic KX-TG1032C Operating Instructions Manual page 40

Useful Information
Battery recharge
Problem
I fully charged the
batteries, but 7
continues to flash.
I fully charged the
batteries, but the operating
time seems to be short.
The handset display is
blank.
Making/answering calls, intercom
Problem
w is displayed, but I
cannot make a call.
Static is heard, sound cuts
in and out. Interference
from other electrical units.
The handset does not ring.
I cannot make a call.
I cannot have a
conversation using the
headset.
I cannot make long
distance calls.
I cannot page the handset.
40
Cause/solution
L Clean the charge contacts and charge again
(page 10).
L The batteries may need to be replaced with new
ones (page 9).
L Wipe the battery ends (S, T) and the unit
contacts with a dry cloth.
L Confirm that the batteries are properly installed.
L Fully charge the batteries (page 9, 10).
Cause/solution
L The handset and base unit could not
communicate for some reason, such as
interference from other electrical appliances.
Perform the following:
– Move the handset and base unit away from
other electrical appliances.
– Move closer to the base unit.
L Move the handset and base unit away from
other electrical appliances.
L Move closer to the base unit.
L If your unit is connected to a telephone line with
DSL service, we recommend connecting a noise
filter between the base unit and the telephone
line jack. Contact your DSL provider for details.
L The ringer volume is turned off. Adjust it (page
23).
L The dialing mode may be set incorrectly.
Change the setting (page 13).
L Another handset is in use. Try again later.
L Make sure that an optional headset is
connected properly (page 37).
L Make sure that you have long distance service.
L The called handset is too far from the base unit.
L The called handset is in use. Try again later.