Whirlpool AWO/D 9614 Instructions For Use Manual page 15

Description of red indications
Red indication
lights up
(if fitted on your
machine)
"Water tap closed"
"Clean pump"
Red indication
on display
(if fitted on your
machine)
Appliance has no or insufficient water supply. The
"Start/Pause" light flashes.
Check whether:
• Water tap is fully open and water supply pressure
• Kinks are present in the water inlet hose.
• Mesh filter of water supply hose is blocked (see
• The water hose is frozen up.
• The safety valve inspection window of your water
---
After problem has been removed, restart
programme by pressing "Start/Pause". If the fault
occurs again, contact our After-Sales Service (see
next chapter).
Waste water is not pumped out. The appliance
stops in the corresponding programme step; unplug
it and check whether:
• Kinks are present in the drain hose.
• Filter or pump is blocked (see chapter "Removing
---
• The drain hose is frozen up.
After problem has been removed, select and start
the "Drain" programme or push the "Reset" button
for at least 3 seconds; afterwards restart the desired
programme. If the fault occurs again, contact our
After-Sales-Service (see next chapter).
GB 11
Description
Causes
Solutions
is sufficient.
"Care And Maintenance".
supply hose is red (provided your appliance has a
water supply hose as shown on picture "B" - see
previous chapter "Care And Maintenance");
replace the hose by a new one available through
our After-Sales Service or your specialist dealer.
The Filter/Draining Residual Water"; make sure
the water has cooled before draining the
appliance).