Table of Contents
Advertisement
Do not let the Blades turn when the Mower Deck is raised for any rea-
son, including clearance or for turning. Raising the Mower deck exposes
the Cutting Blades which creates a potentially serious hazard and could
cause serious injury or even death from objects thrown from the Blades.
(SRM-07)
Maintenance and Service Safety Instructions and Practices
Make sure the PTO shield, integral driveline shields, and input shields
are installed when using PTO-driven equipment.
shield if it is damaged or missing.
Always disconnect the main PTO Driveline from the Tractor before performing service on
the Implement. Never work on the Implement with the tractor PTO driveline connected and
running. Rotating Parts, Blades or Drivelines could turn without warning and cause immedi-
ate entanglement, injury or death.
Never interfere with factory-set hydraulic calibrations.
cause a failure of the equipment and may result in injury.
Relieve hydraulic pressure prior to doing any maintenance or repair work on the Implement.
Place the Mower Head on the ground or securely supported on blocks or stands, disengage
the PTO, and turn off the engine. Push and pull the control Levers or Joystick several times
to relieve pressure prior to starting any maintenance or repair work.
Always disconnect the wire leads from the mower pump solenoid
before performing service on the Tractor or Mower. Use caution when
working on the Tractor or Mower.
Mower or Tractor. The Mower Blades could inadvertently be turned on without warning
and cause immediate dismemberment, injury or death.
All Safety Shields, Guards and Safety devices including (but not
limited to) - the Deflectors, Chain Guards, Steel Guards, Gear-
box Shields, PTO integral shields , and Retractable Door Shields
should be used and maintained in good working condition. All safety devices
should be inspected carefully at least daily for missing or broken components.
Missing, broken, or worn items must be replaced at once to reduce the possibility
of injury or death from thrown objects, entanglement, or blade contact.
A-BOOM 02/10
© 2010 Alamo Group Inc.
SAFETY
(S3PT-8)
(S3PT-11)
Tractor engine must be stopped before working on
(SBM-12a)
Safety Section 1-12
Always replace any
Any change in calibration could
(SBH-13)
(SBM-6)
(SBM-18)
Advertisement
Table of Contents
