Table of Contents
Advertisement
MAINTENANCE
Flail Axe Head
Belt Tension:
When installing new belts, tighten belts to obtain a 16 lb. Belt Deflector Force at 7/16" deflection. After a few
hours of operation to allow the belts to seat into the sheave grooves recheck and adjust as needed to obtain an
8 to 12 lb. Belt Deflection Force at 7/16" deflection. Inspect belts and recheck belt tension periodically to
maintain an 8 to 12 lb. Belt Deflection Force at 7/16" deflection.
TAPER BUSHING & SHEAVE INSTALLATION
Do not use lubricants during installation as this may cause sheave breakage.
Make sure the bushing and bore of the sheave are free of dirt, paint, metal chips, etc.
Insert cap screws and lockwashers engaging only 2 or 3 threads.
With key in the keyway, slide the loosely assembled unit onto the shaft and position for good belt alignment.
Temporary shimming under the pulley may make it easier to position.
Carefully tighten cap screws alternately and progressively until tapers are seated (about 5 FT-LB).
Check sheave alignment and runout (wobble).
Continue careful alternate and progressive tightening of cap screws to 10 FT-LB.
Maximum torque should be achieved on each individual bolt only two times.
ABOOM 02/10
Maintenance Section 4-14
©2010 Alamo Group Inc.
Advertisement
Table of Contents
