Optional Blower Installation - Napoleon GDS26N Installation And Operating Instructions Manual

7.0 OPTIONAL BLOWER INSTALLATION

TURN OFF THE GAS AND ELECTRICAL POWER BEFORE SERVICING THIS APPLIANCE.
USE ONLY WOLF STEEL APPROVED OPTIONAL ACCESSORIES AND REPLACEMENT PARTS WITH
THIS APPLIANCE. USING NON-LISTED ACCESSORIES (BLOWERS, DOORS, LOUVRES, TRIMS, GAS
COMPONENTS, VENTING COMPONENTS, ETC.) COULD RESULT IN A SAFETY HAZARD AND WILL
ENSURE THAT THE FAN'S POWER CORD IS NOT IN CONTACT WITH ANY SURFACE OF THE
APPLIANCE TO PREVENT ELECTRICAL SHOCK OR FIRE DAMAGE. DO NOT RUN THE POWER
THE WIRE HARNESS PROVIDED IN THE BLOWER KIT IS A UNIVERSAL HARNESS. WHEN
INSTALLED, ENSURE THAT ANY EXCESS WIRE IS CONTAINED, PREVENTING IT FROM MAKING
ELECTRICAL INSTALLATION TO BE DONE BY A QUALIFIED INSTALLER and must be connected and
grounded in accordance with local codes. In the absence of local codes, use the current CSA C22.1 Canadian
Electrical Code in Canada or the current ANSI/NFPA 70 National Electrical Code in the United States.
Break out the blower and thermal switch knock-outs from the rear panel.
A.
Fish the wire extension through the blower knock-out as shown and connect to the prongs on the thermal
B.
switch.
Ensure the thermal switch is touching the wall of the fi rebox. Secure the
C.
thermal switch assembly to the rear panel using 4 of # 8 screws supplied.
Connect the variable speed switch to the jumper wire (installed in the
D.
appliance) located just inside the larger knock out area.
Insert the blower assembly into the rear panel and secure using the
E.
remaining #8 screws supplied.
Remove the switch housing, connect the variable speed switch to the jumper
F.
wire and mount the switch to the side of the housing. Attach and secure the variable speed switch using
the nut provided. Reinstall the switch housing. Install the variable speed switch knob.
VARIABLE SPEED SWITCH
JUMPER WIRE
VARIABLE
SPEED
SWITCH
KNOB
RED
BLOWER
RISK OF FIRE AND ELECTRICAL SHOCK.
VOID THE WARRANTY AND CERTIFICATION.
CORD BENEATH THE APPLIANCE.
CONTACT WITH MOVING OR HOT OBJECTS.
GS67 WIRING DIAGRAM
LOCATED
IN WIRE
HOUSING
(installed in fireplace)
WHITE
BLACK
BLACK
WIRE
HARNESS
(included in GS67 kit)
GREEN
(GROUND) TO
POWER
SUPPLY
WARNING
!
SWITCH
HOUSING
THERMAL SWITCH
WIRE
EXTENSION
51.5
THERMAL SWITCH
KNOCK-OUT
BLOWER
KNOCK-OUT
VARIABLE
SPEED
SWITCH
THERMAL
LOCATION
SWITCH
ASSEMBLY
BLOWER
ASSEMBLY
W415-1333 / 06.25.14
35
EN
GROUND
SCREW