Door Glass Replacement; Log Placement - Napoleon GDS26N Installation And Operating Instructions Manual

6.2

DOOR GLASS REPLACEMENT

CARE MUST BE TAKEN WHEN REMOVING AND DISPOSING OF ANY BROKEN DOOR GLASS OR
DAMAGED COMPONENTS. BE SURE TO VACUUM UP ANY BROKEN GLASS FROM INSIDE THE
DO NOT STRIKE, SLAM OR SCRATCH GLASS. DO NOT OPERATE APPLIANCE WITH GLASS
Place the door frame face down careful not to
A.
scratch the paint.
Center the gasketed glass inside the door frame
B.
with the thick side of the gasket facing up.
Bend the glass retainers located along the edge
C.
of the door frame over the gasket holding the
glass in place. Careful not to break the glass.
6.3

LOG PLACEMENT

FAILURE TO POSITION THE LOGS IN ACCORDANCE WITH THESE DIAGRAMS OR FAILURE TO USE
ONLY LOGS SPECIFICALLY APPROVED WITH THIS APPLIANCE MAY RESULT IN PROPERTY
LOGS MUST BE PLACED IN THEIR EXACT LOCATION IN THE APPLIANCE. DO NOT MODIFY THE
PROPER LOG POSITIONS, SINCE APPLIANCE MAY NOT FUNCTION PROPERLY AND DELAYED
In order to assemble the log set, the glass door must be removed, see "GLASS DOOR INSTALLATION AND
REMOVAL"section.
Place the rear log as shown, ensuring the
A.
holes on the underside are placed onto the
two pins of the log support.
Place the center log as shown, follow
C.
contour of burner and ensure port holes are
not covered.
DO NOT USE SUBSTITUTE MATERIALS.
GLASS MAY BE HOT, DO NOT TOUCH GLASS UNTIL COOLED.
APPLIANCE BEFORE OPERATION.
REMOVED, CRACKED, BROKEN OR SCRATCHED.
DAMAGE OR PERSONAL INJURY.
IGNITION MAY OCCUR.
THE LOGS ARE FRAGILE AND SHOULD BE HANDLED WITH CARE.
BRACKET
WARNING
!
56.1A
WARNING
!
Place the left log as shown, ensuring the hole
B.
on the underside is placed onto the burner pin.
This will rest on the left side of the rear log.
Place the hole in the underside of the right
D.
log onto the locating pin, on the burner base
and rests against the rear log as shown.
Re-install the glass door.
E.
GASKET
GLASS
GLASS
RETAINER
DOOR
FRAME
76.1A
W415-1333 / 06.25.14
33
EN