Table of Contents
Advertisement
b-1
SAFETY PRECAUTIONS
Read and understand this entire section before
operating your RANGER® 305LPG.
Do not attempt to use this equipment until you
have thoroughly read all operating and mainte-
nance manuals supplied with your machine. They
include important safety precautions, detailed
engine starting, operating and maintenance
instructions and parts lists.
ELECTRIC SHOCK can kill.
•Do not touch electrically live parts
such as output terminals or internal
wiring.
•Insulate yourself from the work and
ground.
•Always wear dry insulating gloves.
------------------------------------------------------------------------
ENGINE EXHAUST can kill.
•Use in open, well ventilated areas or
vent exhaust outside
•Do not stack anything near the
engine.
------------------------------------------------------------------------
MOVING PARTS can injure.
•Do not operate with doors open or
guards off.
•Stop engine before servicing.
•Keep away from moving parts
------------------------------------------------------------------------
• Only qualified personnel should operate this
equipment.
ADDITIONAL SAFETY PRECAUTIONS
Always operate the welder with the hinged door
closed and the side panels in place as these pro-
vide maximum protection from moving parts and
insure proper cooling air flow.
GENERAL DESCRIPTION
The RANGER® 305LPG is a gasoline engine pow-
ered DC multi-process welding power source and 120
/ 240 volt AC power generator. The engine drives a
generator that supplies three phase power for the DC
welding circuit and single phase power for the AC
auxiliary outlets. The DC welding control system uses
state of the art Chopper Technology
welding performance. The RANGER 305LPG is NOT
RECOMMENED for pipe thawing.
OPERATION
FOR AUXILIARY POWER:
Start the engine and set the IDLER control switch to
the desired operating mode. Full power is available
regardless of the welding control settings providing no
welding current is being drawn.
The auxiliary power of the RANGER® 305LPG con-
sists of two 20 Amp-120 VAC GFCI (5-20R) duplex
receptacles and one 50 Amp 120/240 VAC (14-50R)
receptacle. The 240 VAC receptacle can be split for
single phase 120 VAC operation.
ENGINE OPERATION
Before Starting the Engine:
• Be sure the machine is on a level surface.
• Open top engine door and remove the engine oil
dipstick and wipe it with a clean cloth. Reinsert the
dipstick and check the level on the dipstick.
• Add oil (if necessary) to bring the level up to the full
mark. Do not overfill. Close engine door.
• See Engine Owner's Manual for specific oil recom-
mendations.
for superior
RANGER® 305LPG
WARNING
• The combustion of LPG fuel
does produce carbon monoxide.
Although the level of CO
sion is lower than gasoline com-
bustion, the exhaust from the
Ranger® 305LPG can kill.
• Avoid breathing of vapor.
• Keep sparks and flame away
from tank.
b-1
emis-
2
Advertisement
Table of Contents
