Operation; Safety Precautions; General Description; For Auxiliary Power - Lincoln Electric RANGER 305D Operator's Manual

b-1

SAFETY PRECAUTIONS

WARNING
Do not attempt to use this equipment until you
have thoroughly read the engine manufacturer's
manual supplied with your welder. It includes
important safety precautions, detailed engine
starting, operating and maintenance instructions,
and parts lists.
------------------------------------------------------------------------
ELECTRIC SHOCK can kill.
• Do not touch electrically live parts or
electrode with skin or wet clothing.
• Insulate yourself from work and
ground
• Always wear dry insulating gloves.
• Always operate the welder with the hinged door
closed and the side panels in place.
• Read carefully the Safety Precautions page
before operating this machine. Always follow
these and any other safety procedures included
in this manual and in the Engine Instruction
Manual.

GENERAL DESCRIPTION

The RANGER® 305D is a diesel engine powered DC
multi-process welding power source and 120 / 240
volt AC power generator. The engine drives a genera-
tor that supplies three phase power for the DC weld-
ing circuit and single phase power for the AC auxiliary
outlets. The DC welding control system uses state of
the art Chopper Technology (CT tm) for superior weld-
ing performance.

FOR AUXILIARY POWER:

Start the engine and set the IDLER control switch to
the desired operating mode. Full power is available
regardless of the welding control settings providing no
welding current is being drawn.
The auxiliary power of the RANGER® 305D consists
of two 20 Amp-120 VAC (5-20R) duplex receptacles
with GFCI protection and one 50 Amp 120/240 VAC
(14-50R) receptacle. The 240 VAC receptacle can be
split for single phase 120 VAC operation. Also refer to
the AUXILIARY POWER OPERATION section later in
this chapter.

ENGINE OPERATION

Before Starting the Engine:
• Be sure the machine is on a level surface.
• Open top & side engine doors and remove the
engine oil dipstick and wipe it with a clean cloth.
Reinsert the dipstick and check the level on the dip-
stick.

OPERATION

• Add oil (if necessary) to bring the level up to the full
mark. Do not overfill. Close engine door.
• Check radiator for proper coolant level. (Fill if nec-
essary).
• See Engine Owner's Manual for specific oil and
coolant recommendations.

ADD FUEL

DIESEL FUEL
can cause fire.
DIESEL FUEL ONLY-Low sulphur fuel or ultra low
sulphur fuel in U.S.A. and Canada.
--------------------------------------------------------------------------------
• Remove the fuel tank cap.
• Fill the tank approximately 4 inches (100mm) from
the top of the filler neck to allow for fuel expansion .
DO NOT FILL THE TANK TO THE POINT OF
OVERFLOW.
• Replace the fuel cap and tighten securely.
• See Engine Owner's Manual for specific fuel recom-
mendations.
bREAK-IN PERIOD
Any engine will use a small amount of oil during its
"break-in" period. For the diesel engine on the
RANGER® 305D, break-in is about 50 running hours.
Check the oil every four hours during break-in.
Change the oil after the first 50 hours of
operation,every 100 hours thereafter. Change the oil
filter at the second oil change.
During break-in, subject the RANGER® 305D to
moderate loads. Avoid long periods running at
idle. before stopping the engine, remove all loads
and allow the engine to cool several minutes.
--------------------------------------------------------------------------------
RANGER® 305D
WARNING
• Stop engine while fueling.
• Do not smoke when fueling.
• Keep sparks and flame away from
tank.
• Do not leave unattended while fuel-
ing.
• Wipe up spilled fuel and allow
fumes to clear before starting
engine.
• Do not overfill tank, fuel expan-
sion may cause overflow.
CAUTION
b-1