Fuel And Refueling - Ford 2016 Fusion Hybrid Owner's Manual

1. Put the vehicle in position P and switch
the ignition off.
E166527
2. Press the center-rear edge of the fuel
filler door and release to open.
E156032
Note: Hold the handle of the fuel filler
nozzle higher while you insert the nozzle for
easier access.
3. Slowly insert the fuel filler nozzle fully
into the fuel system to open both
doors. Leave the nozzle fully inserted
until you have stopped pumping fuel.
Fusion Energi / Fusion Hybrid (CC7) Hybrid Electric Vehicle (HEV)/Plug-In Hybrid Electric Vehicle (PHEV), Canada/United States of America, enUSA, First Printing

Fuel and Refueling

E154765
Note: Allow about five to ten seconds after
pumping fuel before removing the fuel filler
nozzle. This allows residual fuel to drain
back into the fuel tank and not spill onto the
vehicle.
4. After you have stopped pumping fuel,
Note: A fuel spillage concern may occur if
overfilling the fuel tank. Do not overfill the
tank to the point that the fuel is able to
bypass the fuel filler nozzle. The overfilled
fuel may run down the drain located below
and in front of the fuel filler door.
5. To close the fuel filler door, press the
If the fuel fill inlet did not close properly, a
Check Fuel Fill Inlet message may
appear on the instrument cluster.
At the next opportunity, do the following:
1.
2. Put the vehicle in position P and switch
3. Open the fuel filler door and remove
4. Insert the fuel fill nozzle, or the fuel fill
161
slowly remove the fuel filler nozzle.
center rear edge of the fuel filler door
and then release. The fuel door will
latch closed.
Safely pull off the road.
the ignition off.
any visible debris from the fuel fill
opening.
funnel provided with your vehicle,
several times to allow the inlet to close
properly. This will dislodge any debris
preventing the inlet from sealing.