Releasing - Mercedes-Benz E-Class Coupe Operator's Manual

Example: Coupe
X
Adjust the seat and move the backrest to
an almost vertical position (
X
Pull the seat belt smoothly out of seat-belt
extender :.
X
Without twisting it, guide the shoulder
section of the seat belt across the middle
of your shoulder and the lap section across
your hips.
X
Engage belt tongue ; in buckle =.
Seat-belt adjustment: if necessary, the
driver's and front-passenger seat belts
automatically adjust to the upper body
( Y page 53).
X
If necessary, pull upwards on the shoulder
section of the seat belt to tighten the belt
across your body.
All seat belts except the driver's seat belt are
equipped with a special seat belt retractor to
securely fasten child restraint systems in the
vehicle. For further information on special
seat belt retractors, see (
For more information about releasing the seat
belt with release button ?, see "Releasing
seat belts" ( Y page 53).
Y page 102).
Y page 57).
I n f o r ma t i o n P r o v i d e d b y :
Occupant safety
Seat belt adjustment
The seat-belt adjustment function adjusts the
driver's and front-passenger seat belt to the
upper body of the occupants.
The belt strap is tightened slightly when:
you engage the belt tongue in the belt
R
buckle and you then turn the SmartKey to
position 2 in the ignition lock.
the SmartKey is in position 2 in the ignition
R
lock and you then engage the belt tongue
in the buckle once the seat-belt extender
has retracted.
The seat-belt adjustment will apply a
retraction force if any slack is detected
between the occupant and the seat belt. Do
not hold on to the seat belt tightly while it is
adjusting. You can switch the seat-belt
adjustment on and off in the on-board
computer ( Y page 211).
The seat-belt adjustment is an integral part of
®
the PRE-SAFE convenience function. More
information about PRE-SAFE
®
in the "PRE-SAFE (preventative occupant
protection)" section (
Releasing seat belts
X
Press release button ? (
guide belt tongue ; back towards seat
belt extender :.
! Make sure that the seat belt is fully rolled
up. Otherwise, the seat belt or belt tongue
will be trapped in the door or in the seat
mechanism. This could damage the door,
the door trim panel and the seat belt.
Damaged seat belts can no longer fulfill
their protective function and must be
replaced. Consult an authorized Mercedes-
Benz Center.
Belt warning for the driver and front
passenger
Regardless of whether the driver and front
passenger have fastened their seat belts
already, the 7 seat belt warning lamp
®
can be found
Y page 48).
Y page 52) and
Z
53