Mechanical Disassembly - Sanyo PLC-XU116 Service Manual

Mechanical Disassembly

Mechanical disassembly should be made following procedures in numerical or-
der.
Following steps show the basic procedures, therefore unnecessary step may
be ignored.
Caution:
The parts and screws should be placed exactly the same position as the original
otherwise it may cause loss of performance and product safety.
1. Cabinet Top, Front, R/C Board removal
1. Remove 5 screws A(T3x10) to remove the cabinet top.
2. Remove 2 screws B(M2.5x6) and 2 screws C(T3x8) to
the Cabinet front.
3. Remove screw D(M2.5x6), 2 screws E( T2x6) and screw
F(M2.5x6) to remove the Lens spacer sheet and Front
shield.
4. Remove 2 screws G(T2x8) to remove the
Antenna board.
5. Remove screw H(T2x8) to remove the R/C Board.
Antenna Board
R/C Board
C
Cabinet front
C(T3x8)x2
F (M2.5x6)
B
G (T2x8)x2
G
H (T2x8)
DEC Inlay LED front
B (M2.5x6)x2
A
Dec Inlay LED
D (M2.5x6)
E
E (T2x6)x2
Lens spacer sheet
-14-
Screws Expression
(Type
Diameter x Length
T type M Type
A (T3x10)x5
Cabinet top
Control Buttons
A
Front shield
Fig.1
) mm
A
A