Standby Mode Notice - Sanyo PLC-XU116 Service Manual

Standby mode Notice

This function is available when operating the projector via network.
Network......Supply the power to the network function even after turning off the projector. You can turn on/ off the
projector via network, modify network environment, and receive an e-mail about projector status while
the projector is powered off.
Eco............. Select "Eco" when you do not use the projector via network. The projector's network function will stop
when turning off the projector.
When "Eco" is selected, several functions will be restricted.
(Power consumption when standing by increases in the state of "Network". )
Restricted Function at the Eco mode
Function
Serial command control
Network Function
Monitor Out
Audio Out
On start
Wired Remote Control
(When wired remote con-
trol code is same as the
remote control code set in
projector setting menu)
Wired Remote Control
(When wired remote con-
trol code is different from
the remote control code set
in projector setting menu)
eco mode
-13-
X
X
X
X
X