Service Bulletin Hk2001-02 - Harman Kardon AVR65 Service Manual

A/v dolby digital receiver
Hide thumbs Also See for AVR65:
Table of Contents

Advertisement

harman/kardon
Service bulletin # H/K2001-02 June 2001
To: All harman/kardon Service Centers
Models: AVR35/45/65, (US,SG,RDS Models)
Subject: Left, Right, or Center channel Dead
In the event you receive an AVR35, 45, or 65 A/V receiver with the complaint: "One channel has no
output", check the item below:
One or more of the 10 ohm fusible resistors R445,446,447,448,523, or 524 on the main PCB may be damaged.
Perform with an ohmmeter an in-circuit resistance test of these 6 resistors. The Ohmmeter should read
10 ohms ±10%. If one or more resistors are out of tolerance, all 6 resistors (R445,446,447,448,523,524) should
be changed to 10 ohm 1/4W metal film type, h/k part# 271-10.
1) Disconnect all external cables; remove the top cover (16 Black Phillips screws).
2) See page 2 for exact location of R445,446,447,448,523,524. If any resistors are found out of tolerance, proceed
with the following steps:
3) Lay unit on its left side on a padded surface; remove the (8) Phillips screws holding the bottom chassis grille on,
which will expose the Main PCB. Remove the two "feet" that are partially covering the grille.
4) Recommended procedure for resistor replacement is to cut each part off the main PCB from the top, then solder
the replacement part on the bottom of the PCB in the same location. There may be a square foam cushion on the
bottom of the PCB covering the area(s) of one or more resistors pads; remove it. Use caution when correctly
identifying each location, comparing the top and bottom of the main PCB. Tip: Resistors are represented by a
silkscreen on the bottom of the main PCB by this line:
Serial Number
Model
JS0007-01001
AVR35
JS0007-16390
AVR35RDS
AVR35SG
JS0001-01001
AVR45
JS0001-12782
AVR45RDS
AVR45SG
JS0003-01001
AVR65
JS0003-06422
AVR65RDS
AVR65SG
harman/kardon Incorporated 250 Crossways Park Drive, Woodbury New York 11797 (516) 496-3400
Serial Number
120V
to
JS0005-01001
n/a
JS0005-06000
JS0009-01001
n/a
JS0009-02537
to
JS0004-01001
n/a
JS0004-04453
JS0008-01001
n/a
J30008-02980
to
JS0006-01001
n/a
JS0006-01777
JS0010-01001
n/a
JS0010-01464
Service Bulletin
230V
R445,446,447,448,523,
n/a
524 are fusible resistors
R445,446,447,448,523,
to
524 are fusible resistors
R445,446,447,448,523,
to
524 are fusible resistors
R445,446,447,448,523,
n/a
524 are fusible resistors
R445,446,447,448,523,
to
524 are fusible resistors
R445,446,447,448,523,
to
524 are fusible resistors
R445,446,447,448,523,
n/a
524 are fusible resistors
R445,446,447,448,523,
to
524 are fusible resistors
R445,446,447,448,523,
to
524 are fusible resistors
Warranty labor rate: MAJOR repair
STATUS
If damaged, replace
with 10 ohm 1/4W
metal film resistors
If damaged, replace
with 10 ohm 1/4W
metal film resistors
If damaged, replace
with 10 ohm 1/4W
metal film resistors
If damaged, replace
with 10 ohm 1/4W
metal film resistors
If damaged, replace
with 10 ohm 1/4W
metal film resistors
If damaged, replace
with 10 ohm 1/4W
metal film resistors
If damaged, replace
with 10 ohm 1/4W
metal film resistors
If damaged, replace
with 10 ohm 1/4W
metal film resistors
If damaged, replace
with 10 ohm 1/4W
metal film resistors
ACTION
26

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents