Signal Condition
Selects a channel and checks the signal condition.
A good Signal Strength is not an indication of suitable signal for freesat / DVB
reception.
Use the Signal Quality indicator as follows.
●
– Green bar: Good
– Yellow bar: Poor
– Red bar: Bad (Check the terrestrial aerial or satellite dish)
Vertical lines show the maximum signal value of the selected channel.
●
To change the channel
●
For freesat and DVB mode
●
Add New Channels
You can add any new channels found automatically to Channel List.
1. The signal condition is displayed and press
If you select
Any Satellite
●
It takes a while to check the connection for your selected satellite.
●
Ensure that the
●
locked, the search cannot be executed.
If the status is shown as
●
Strength
have no indications, please check the dish alignment.
2. Select the search mode with
Channels
New channels can only be added to the existing Channel List from the
●
same satellite.
in
Auto
Setup, this step is skipped.
Signal Lock
status is shown as Locked. If it is not
Not locked
/
and press
- 66 -
OK
to access
and
Signal Quality
/
OK
to start
Add New
Signal