Performing A System Backup - TrekStor SurfTab wintron 10.1 3G Operating Instructions Manual

c) Tap "s " in the Charm Bar.
ettings
d) Now tap "C
hange
e) Tap "u
pDate aMD reCovery
" (centre of the screen).
get installeD
f ) Under "i
Mporant upDates
updates in future.
Further down on the same screen, you can also specify how the SurfTab should
i
handle other forms of updates ("r
g) Confirm your selection with "a

18) Performing a system backup

To enable a system recovery (including all data) in the event of failure, the
SurfTab allows you to make a "system image" backup. We recommend
performing the backup using an external hard drive. To do so, proceed as follows:
a) Connect an external hard drive to the USB 2.0 port on the SurfTab using a
USB cable.
b) Open the Charm Bar by swiping your finger inwards from the right-hand
edge of the screen.
c) Tap "s " in the Charm Bar.
ettings
d) Now tap "C
hange
e) Tap "C p
ontrol
Panel in the desktop view opens.
f ) Tap "F
ile history
g) Tap "s
ysteM iMage baCkup
The SurfTab asks whether you would like to save the backup.
h) In this window, select (highlight) "o
window directly beneath, select the connected external hard drive as the
target drive for saving the system image.
i) Confirm by tapping "n
SurfTab shows which drives will be backed up. Confirm by tapping "s
b ".
baCkup
The system image is created and stored on the hard drive.
pC " in the bottom-right area.
settings
" in the bottom-left area and then "C
", select how the SurfTab should proceed with
eCommeNded updates
pply
pC " in the bottom-right area.
settings
" in the bottom-left area in the device settings. The Control
anel
" in the Control Panel.
" in the bottom-left area of the following window.
" in the bottom-right area of the window. The
ext
" and "m
".
", and in the drop-down
n a harD Disk
hoose hoW upDates
u ").
iCrosoft pdate
tart
EN
25