Download Print this page
Lincoln Electric CAN-F30 User Manual
Lincoln Electric CAN-F30 User Manual

Lincoln Electric CAN-F30 User Manual

Lincoln welder user manual

Advertisement

Quick Links

M A T E R I A L S A F E T Y D A T A S H E E T
Conforms to Workplace Hazardous Materials Information System (WHMIS) Rev. November, 1988
Section I & II - Preparation and Product Information
The Lincoln Electric Company of Canada LP
179 Wicksteed Avenue
Toronto, Ontario M4G 2B9 CANADA
Phone: (416) 421-2600
I M P O R T A N T !
This section covers the materials from which this product is manufactured. The fumes and gases produced during welding with the normal use of this
product are covered by Section VII; see it for industrial hygiene information.
CAS Number shown is representative for the ingredients listed.
(1)
The term "hazardous" in "Hazardous Ingredients" should be interpreted as a term required and defined in the Hazardous Products Act and
does not necessarily imply the existence of any hazard.
Ingredients:
Magnesite
Aluminum oxide and/or Bauxite
Mineral silicates
Fluorides (as F)
Silicates and other binders
Manganese and/or manganese alloys and compounds (as Mn)
Silicon and/or silicon alloys and compounds (as Si)
Iron
Crystalline-Silica (cristobalite)
Notes:
(*)
Not listed. Nuisance value maximum is 10 milligrams per cubic
meter. TLV value for iron oxide is 5 milligrams per cubic meter.
(**)
As respirable dust. Value for respirable quartz is 0.05 milligrams
per cubic meter.
Physical data such as odor, vapor pressure, density, evaporation rate and freezing or boiling points are not listed as they are not applicable
to this product and its use.
Non Flammable; Welding arc and sparks can ignite combustibles and flammable products. See CSA W117.2 Section 9.7 as referenced in
Section VIII. Product is inert, no special handling or spill procedures required.
Rev 9/07
Date:
Trade Name:
Sizes:
Supersedes:
For Welding Consumables and Related Products
Product Type:
Representative Classifications:
Section III - Hazardous Ingredients (1)
CAS No. Wt. %
1309-48-4
1344-28-1
1332-58-7
7789-75-5
1344-09-8
7439-96-5
7440-21-3
7439-89-6
14464-46-1
Section IV - Physical Data
Section V - Hazard Data
MSDS No.:
6/1/2008
Lincolnweld 801
---
11/1/07
Prepared by The Lincoln Electric Company, Cleveland, Ohio, USA
(216) 481-8100, on the date shown above.
TLV
3
mg/m
(Route/Species)
30-60
10
10-30
10
10-30
5**
10-30
2.5
5-10
10*
1-5
0.2
0.1-1
10*
0.1-1
10*
0.1-1
#0.025**
(LDLo, LCLo) Lowest published toxic
concentration.
(#)
Crystalline silica (quartz) is on the IARC (International
Agency for Research on Cancer) and NTP (National
Toxicology Program) lists as posing a carcinogenic risk
to humans.
(CONTINUED ON SIDE TWO)
CAN-F30
Submerged Arc Flux
None
LD
LC
50
50
(Route/Species)
Not Available
Not Available
Not Available
Not Available
590 g/kg LDLo
Not Available
(oral/rat) reproductive
4250 mg/kg
Not Available
(oral/rat)
1153 mg/kg
Not Available
(oral/rat)
9 g/kg
2.3 LCLo
(oral/rat)
(inhalation/human)
Not Available
Not Available
Not Available
Not Available
10,000 mg/kg
Not Available
(oral/rat)
3
mg/m

Advertisement

loading

Summary of Contents for Lincoln Electric CAN-F30

  • Page 1 Date: 6/1/2008 Trade Name: Lincolnweld 801 Sizes: Supersedes: 11/1/07 Product Type: Representative Classifications: Prepared by The Lincoln Electric Company, Cleveland, Ohio, USA (216) 481-8100, on the date shown above. CAS No. Wt. % mg/m 1309-48-4 30-60 1344-28-1 10-30 1332-58-7 10-30...
  • Page 2 At a minimum this includes welder's gloves and a protective face shield, and may include arm protectors, aprons, hats, shoulder protection, as well as dark substantial clothing. Train the welder not to permit electrically live parts or electrodes to contact skin . . . or clothing or gloves if they are wet. Insulate from work and ground.