Summary of Contents for Lincoln Electric COOLARC-50C
Page 1
IM3038 02/2011 Rev. 00 COOLARC-50C OPERATOR’S MANUAL LINCOLN ELECTRIC BESTER Sp z o.o. ul. Jana III Sobieskiego 19A, 58-260 Bielawa, Poland www.lincolnelectriceurope.com...
Page 2
EN 60974-2, EN 60974-1, EN 60974-10 (2011) Paweł Lipi ski Operational Director LINCOLN ELECTRIC BESTER Sp z o.o., ul. Jana III Sobieskiego 19A, 58-260 Bielawa, Poland...
Page 3
By applying this European Directive you will protect the environment and human health! 12/05 THANKS! For having chosen the QUALITY of the Lincoln Electric products. Please Examine Package and Equipment for Damage. Claims for material damaged in shipment must be notified •...
Page 4
Failure to follow the instructions in this manual could cause serious personal injury, loss of life, or damage to this equipment. Read and understand the following explanations of the warning symbols. Lincoln Electric is not responsible for damages caused by improper installation, improper care or abnormal operation.
“MINIMUM LIQUID LEVEL” on with water cooled TIG, MIG. label. COOLARC-50C cooler is designed for use with all water- Air flow louvers (E): Air flow louvers secure adequate air cooled gun’s up to 500A, TIG and MIG torches and circulation.
Page 6
Be certain to replace the reservoir fill cap when the Keep the reservoir full especially after changing any • reservoir is full. Operation of the COOLARC-50C cooler water lines. without the fill cap in place can cause poor cooling Avoid placing the cooler near areas of extreme heat.
Page 7
RESULT: THE TORCH FEELS HOTTER. Unlike other water coolers that depend on bulky reservoir size, the high efficiency components of COOLARC-50C cooler allows the reservoir size to be small. The result is a lightweight, portable unit.
Lincoln Electric. Before installing the machine, the operator must check the work area for any devices that may malfunction because of electromagnetic disturbances.
3,3 l/min Reservoir size 9,2 l Coolant requirement: Recommended coolant for COOLARC-50C: Acorox Do not use prepackaged welding industry coolants. These Water or water and pure ethylene glycol mixture can be coolants may contain oil-based substances which attack used interchangeably.