Table of Contents
Advertisement
WARNING!
Make sure all the parts of burner are assembled in correct order before switching on
or after cleaning.
IMPORTANT:
Do not mix out top and bottom.
The locating lugs must fit exactly into the notches.
Please follow the procedures (refer Fig. 3).:
- Fit the burner cover ① onto the burner base.
- Fit the outer copper coil ② on the burner cover ①.
- Fit the outer cap ③ on the outer copper coil ②.
- Fit the inner copper coil ④ on the burner cover ①.
- Fit the inner cap ⑤ on the inner copper coil ④.
Routine maintenance
Have the condition and efficiency of the gas pipe and the pressure regulator (if
installed) checked periodically. If anomalies are found, do not repairs but have the
faulty part replaced.
To ensure good performance and safety, the gas regulator taps must be greased
periodically.
Periodic lubrication of the taps must only be carried out by qualified
personnel, who must also be contacted if the appliance malfunctions.
Service and parts
Before leaving the factory, this appliance was tested and adjusted by specialist skilled
staff to give the best operating results. Any subsequent necessary repairs or
adjustments must be carried out with the greatest care and attention.
For this reason, we strongly advise you always to contact the Dealer who sold you the
appliance or our nearest Service Centre, specifying the nature of the problem, the
model of the
equipment,
in the plate on the cover of this manual. Always request the use of original spare
parts.
product number and serial number. These data are provided
10
Hide quick links:
Advertisement
Table of Contents
