Installation Wizard
•
Using Internet Services. For instructions refer to
CentreWare Internet Services (WorkCentre
•
With the Wireless Setting Program. For instructions refer to
Note:
Performing the driver installation at this time may aid wireless setup. Refer to
Configure Wireless Connectivity at the Machine
1.
Press the Machine Status button.
Press the up/down arrows to select Network and press OK.
2.
3.
Enter the Administrator Password using the alphanumerical keypad. The default is 1111.
4.
Press the up/down arrows to select Wi-Fi and press OK. This allows you to select the Wi-Fi setup.
The options are:
•
Wi-Fi On/Off - allows you to turn Wi-Fi On or Off.
•
Wi-Fi Settings - allows you to use a Wizard to find the wireless network name automatically,
or use the Custom feature to enter the SSID (Service Set Identifier) information manually.
•
WPS - allows you to select the Wi-Fi Protected Setup - the options are PBC or PIN.
•
Wi-Fi Direct - allows you to enable your wireless devices, such as notebooks, mobile phones
and PCs to establish wireless connectivity without the need for a wireless router, access point,
or Wi-Fi hot spots.
•
Wi-Fi Signal - allows you view the strength of the wireless connection.
Wi-Fi Default - allows you to restore the default wireless settings.
•
5.
At the Wi-Fi On/Off menu, confirm that On is selected and press OK.
6.
Press the up/down arrows to select Wi-Fi Settings and press OK. The options are Wizard and
Custom:
a.
Select Wizard - to have the machine find the WPS Settings automatically. If you select this,
the Searching Wi-Fi Network screen displays and the machine searches the wireless network.
•
Select your wireless network and select OK.
•
Enter the wireless security information if requested and select OK.
•
Select Yes to apply the changes.
b.
Select Custom - to edit the SSID information manually. If you select this option, the SSID
screen displays.
•
Enter the SSID using the keypad and select OK.
•
Select the Operation Mode and select OK.
•
Select the Encryption and select OK.
Select the WPA Key and select OK.
•
•
Select Yes to apply the changes.
7.
At the WPS menu, select PBC or PIN.
8.
At the Wi-Fi Direct menu, select On or Off, Device Name, IP Address, Group Owner, Network Key,
and Status.
9.
At the Wi-Fi Signal menu, check to see if there is a Wi-Fi signal.
10. At the Wi-Fi Default menu, select Restore if you want to restore defaults.
30
Xerox® WorkCentre® 3025
User Guide
Configuring Wireless Connectivity Using
3025NI).
Wireless Setting
Program.
Printer
Drivers.