Denon AVR-X1200W Owner's Manual page 224

Contents Connections
Symptom
DTS Neural:X cannot be selected when using the headphones.
DTS Neural:X mode cannot
0
be selected.
Dolby Surround mode Dolby Surround cannot be selected when using the headphones.
0
cannot be selected.
Audyssey MultEQ XT, These cannot be selected when you have not performed Audyssey
®
0
Audyssey Dynamic EQ
®
Switch to a sound mode other than "Direct" or "Pure Direct".
0
and Audyssey Dynamic
These cannot be selected when using the headphones.
0
Volume ® cannot be
selected.
Check that an analog signal or PCM signal (Sample Rate = 44.1/48 kHz) is input. For playback of
"Restorer" cannot be
0
multichannel signals such as Dolby Digital or DTS surround, "Restorer" cannot be used.
selected.
Switch to a sound mode other than "Direct" or "Pure Direct".
0
Digital signal audio input from the HDMI connector or digital audio connectors (OPTICAL/COAXIAL)
No sound is output when
0
cannot be played back. Use analog connections.
using ZONE2.
When listening to the audio of a Bluetooth device in ZONE2, remove any obstructions between the
0
Bluetooth device and this unit and use it within a range of about 32.8 ft/10 m.
Front panel Display
Playback Settings
Cause / Solution
224
Rear panel
Tips
® Setup.
Remote Index
Appendix
Page
－
－
175
121
－
156
121
－
－