1-1. CABINET REMOVAL
1-2. SERVICE POSITION
1
Gently wiggle the A board back and forth to unplug
it from the Neck Assembly.
2
Remove all necessary connections and rotate the
D Board and rest it on its side to expose the bottom.
Be sure to reconnect all wires.
3
Fabricate a temporary ground wire with a male
stakon connector on one end and an alligator clip
on the other.
4
Reconnect ground as shown below.
SECTION 1: DISASSEMBLY
1
— 7 —
1
Remove (4) Screws (+BVTP 4 x 16)
2
Release top claws - Insert the tip of a ß athead
screwdriver approximately 0.25" to unlock the
claw. Gently lift up and then back to remove
the cabinet.
4
HMD-A240
2