Introduction - Mercedes-Benz Audio 10 Operating Instructions Manual

Operating safety
G WARNING
If you operate information systems and
communication equipment integrated in the
vehicle while driving, you will be distracted
from traffic conditions. You could also lose
control of the vehicle. There is a risk of an
accident.
Only operate the equipment when the traffic
situation permits. If you are not sure that this
is possible, park the vehicle paying attention
to traffic conditions and operate the
equipment when the vehicle is stationary.
In addition, observe the legal requirements of
the country in which you are currently driving.
Proper use
Audio 10 can be used to receive radio
stations, to play back SD memory cards and
other data carriers and to make calls via the
®
Bluetooth function.
Observe the requirements in the technical
data for data carriers and permissible
formats.
General notes
Information on the Operating
Instructions
i
This Supplement describes Audio 10 as
was available at the time of this
Supplement going to print. Country-
specific variations are possible.
Therefore, your Audio 10 equipment may
differ from certain descriptions and
illustrations. Should you have any
questions concerning equipment and
operation, consult any authorized
Mercedes-Benz Center.
Qualified specialist workshops
A qualified specialist workshop has the
necessary specialist knowledge, tools and
qualifications to correctly carry out the work
required on Audio 10.
An authorized Mercedes-Benz Center is a
qualified specialist workshop.
Always have modifications to Audio 10
carried out at a qualified specialist workshop.
Declaration of conformity
Radio-based vehicle components
i
USA only: The wireless devices of this
vehicle comply with Part 15 of the FCC
Rules. Operation is subject to the following
two conditions:
1. These devices may not cause
interference, and
2. These devices must accept any
interference, including interference that
may cause undesired operation of the
device.
Changes or modifications not expressly
approved by the party responsible for
compliance could void the user's authority
to operate the equipment.
i
Canada only: The wireless devices of this
vehicle comply with Industry Canada
RSS-210 standard. Operation is subject to
the following two conditions:
1. These devices may not cause
interference, and
2. These devices must accept any
interference, including interference that
may cause undesired operation of the
device.

Introduction

Z
7