Indicator And Projector State - LG BD430 Owner's Manual

Indicator and projector state

Check the indicator to know about the state of projector.
Indicator
POWER/TEMP LAMP
(Green/Red/Orange) (Red)
?
or
• • • green
• • • blinks green
*When the projector lamp reaches its endurance, the indicator light will be yellow and you need to
replace the lamp.
In power-off state (AC power cord not inserted).
In normal working state.
[In standby state]
Standby state. Press POWER button to turn on the projector.
[In power on state]
Environmental temperature is higher than the set operating range
( ). The projector will power off soon.
43°C~47°C
The projector is in suspension state until the lamp is lit.
The projector is preparing for stand-by or the projection lamp is being
cooled down.The projector cannot be turned on until cooling is completed
and the POWER/TEMP indicator is off.
Can't be powered on because error is detected. You should unplug
the power cord. Then insert it again and power on the projector. If the
projector is powered off again, you should cut off the power and contact
the local distributor or repair center. In this case, stop the projector.
Otherwise, electric shock or fire may occur.
The service life of the lamp is over. You should replace it with a new one
in time.
Turning on the lamp error.LAMP indicator blinks red.
• • • red
?
• • • blinks red
State of projector
• • • orange
?
• • • blinks orange
Appendix
• • • off
59