Picture Id - LG 42WS50MS Owner's Manual

Picture ID

Picture ID is used to change the settings of a
specific display using a single IR receiver for multi-
AUDIO
(RGB/DVI)
RS-232C OUT
vision. Communication is possible between a set
RS-232C IN
with an IR receiver and other sets using audio
REMOTE
CONTROL IN
cables. Each set is identified by a set ID. If you
assign the Picture ID using the remote control, only
displays with the same Picture ID and Set ID can
be controlled remotely.
IR Receiver
Audio cable
2X2 Multi-Vision (Total Set ID: 4)
Set IDs are assigned as shown in the picture.
1
Press the red ON button on the remote control
to assign the Picture ID.
2
RS-232C OUT RS-232C OUT
RS-232C IN RS-232C IN
Picture ID
Off
Close
CUSTOMIZING SETTINGS
If you press the left/right buttons or press the
ON button repeatedly, the Picture ID cycles
through OFF and 0 to 4. Assign the ID you
want.
Picture ID
Off
◀
Close
y
If you assign the Set ID to each set with
multi-vision, and then assign the Picture ID
using the red button on the remote control,
the key command is displayed for the set
with the same Set ID and Picture ID. A set
with different Set IDs and Picture IDs cannot
be controlled by IR signals.
y
For more information on how to assign the
Set ID, see "Set ID" on page 47.
y
Please refer to the Installation Manual for
more information on Total Set ID assignment.
NOTE
y
For example, if the Picture ID is assigned to
2, the upper right display (Set ID: 2) can be
controlled by IR signals.
y
For each set, you can change the settings
for the PICTURE, AUDIO, TIME, NETWORK
and MY MEDIA menus or the hot keys on
the remote control.
y
If you press the green OFF button for Picture
IDs, the Picture IDs for all sets are turned off.
If you then press any button on the remote
control, all sets will start working again.
y
Picture ID will be disabled while using the
MY MEDIA menu.
53
▶