Connections - JBL PowerBass Series PB10 Preliminary Service Manual

S P E A K E R C O N N E C T I O N
When we designed the
PB10 and PB12 powered
subwoofers, our goal was
to offer the user the best
possible performance
combined with the most
flexible and complete
installation options. Please
look over the following three
Dolby* Pro Logic* (Non-Digital) – Speaker Level
Use this installation method
for Dolby Pro Logic appli-
cations (not Dolby Digital,
DTS ® or other digital
processing), where the
receiver/processor does not
have a subwoofer output or
a volume-controlled preamp
(line-) level output:
Connect your receiver or
amplifier's front left and right
speaker terminals to the left
and right terminals on the
subwoofer that are marked
"High Level In." Connect the
left and right terminals on the
subwoofer that are marked
"High Level Out" to the cor-
responding terminals on the
examples to determine which
description best matches your
system and follow the
corresponding hookup
instructions.
To use the binding-post
speaker terminals with bare
wire, unscrew the collar until
the hole through the center
back of your front left and
right speakers.
Connect your receiver or
amplifier's center, left and
right surround-speaker
terminals to the corre-
sponding terminals on the
back of your center, left and
right surround speakers.
post is visible under the collar.
Insert the bare end of the wire
through the hole in the post,
then screw the collar back
down until the connection is
tight. The holes in the center
of the collars are intended for
banana-type connectors.
Left Front
Center
+ –
+ –
Subwoofer
L L
HIGH
LEVEL
IN
R R
+ –
L
HIGH
LEVEL
OUT`
R
Receiver
Left Front Center
+ – + –
Left Surround
+ –
Left Surround
+ –
Right Front
+ –
Right Front
+ –
Right Surround
+ –
Right Surround
+ –
4