Oki Microline ML380 Handbook page 32

%Installing the Serial Interface Adapter
Installing the Serial Interface Adapter
The serial interface adapter mounts in the parallel interface cavity on the bottom of the printer.
1.Unplug the printer.
2.Remove the paper separator, optional pull tractor cover and the optional pull tractor, if installed.
3.Remove the knock-out from the side of the printer housing. When you are through installing the
serial interface adapter, the serial interface connector will be located here.
4.Turn the printer over and place it gently on a sturdy, flat surface.
5.Locate the parallel interface connector and push the wire clips to either side.
6.Hold the serial interface adapter with the parallel interface connector and metal tab facing you.
Tilting the adapter, slide the metal tab into the screw hole well and align the connector with the
connector on the printer.
ML 380 ( 96-02-03 )