Oki Microline ML380 Handbook page 17

%Loading Rear Feed Paper w/ Optional Pull Tractor
Loading Rear Feed Paper with Optional Pull Tractor Installed
The superior paper control provided by using both tractors for rear paper feed is especially good when
you're printing on multi-part forms. See page 33 for instructions on how to install the optional pull tractor.
Don't use the Paper Park feature when the pull tractor is installed_the paper will disengage from the pull
tractor if you do.
Be sure the Form Tear-Off feature is set to OFF (the factory default) when you are using the optional pull
tractor. It doesn't work with the pull tractor installed.
Labels should only be fed into the printer from the bottom. This prevents the labels from peeling off and
jamming the printer.
1.Follow steps 1 through 10 above for loading rear feed paper with the built-in tractor.
2.Open the pull tractor access cover.
3.Release the lock levers and open the tractor covers on the pull tractors.
4.Adjust the position of the pull tractors to align their pins with the holes in the paper.
5.Press the SELECT button to deselect the printer.
6.Rotate the platen knob to bring the paper up to the pull tractors.
7.Push the paper lever back to disengage the built-in tractor from the platen so that you can install
the paper on the optional pull tractor.
8.Place the paper holes on the sprocket pins of the pull tractor. You may have to pull the paper up a
bit to align the holes with the pins.
ML 380 ( 96-02-03 )