Restoring Factory Defaults; Completing The Installation; Step 10. Reinstalling The Turret And The Dome Bubble; Figure 2-7 Holding The Dome Bubble In Front Of The Lens - Honeywell HD54IP User Manual

Installation and Setup

Completing the Installation

Step 10. Reinstalling the Turret and the Dome Bubble

28
Figure 2-7 Holding the Dome Bubble in front of the Lens
To adjust the camera position, view angle, and focus, connect the local video out to the
video monitor using the supplied BNC video cable.

Restoring Factory Defaults

Your camera has a Factory Reset button located inside the camera (see
this button to restore your camera options and passwords to their default settings. Use a
pin or straightened paperclip to press and hold the Reset button for five seconds.
When you have set up your camera and completed the network connections:
1. Align the turret on the gimbal assembly, then gently press the turret until it clicks
securely into place.
2. Align the dome bubble captive screws with the mounting holes in the enclosure base,
then securely screw them into place.
Figure 2-6). Use