During First Use; Switching On The Appliance And Setting The Thermostat - Baumatic BRB2617 Instruction Manual

During first use

o You should set the thermostat dial to its maximum setting for 24
hours after switching on the appliance for the first time.
o When you first switch on the appliance, the compressor will run
continuously for approximately 24 hours or until the fridge
freezer reaches a cool enough temperature.
o During this period of time, you should try not to open the door
frequently or place a large amount of food within the appliance.
o You should then adjust the thermostat dial down to its normal
operating position.
o If the unit is switched off or unplugged, you must allow at least 5
minutes before restarting the appliance on the thermostat or
connecting it to your mains supply.

Switching on the appliance and setting the thermostat

You switch on your appliance by connecting it to your mains supply
and setting the thermostat. The thermostat dial is located on the
control panel, which can be found at the top of the fridge freezer.
o The thermostat automatically regulates the temperature inside
the fridge freezer, depending on which setting you have turned
the thermostat dial to.
o You should turn the thermostat dial clockwise.
o If the arrow is positioned to the smaller dots, then you will get a
higher temperature inside the fridge and freezer sections.
o If the arrow is positioned to the larger dots, then you will get a
lower temperature inside the fridge and freezer sections.
11