Table of Contents
Advertisement
Control of this unit is via the Sensitivity control knob – this will adjust how the
•
unit reacts to bass notes and beats within the audio spectrum.
Care should be taken to ensure this product is operated in accordance within
•
the HSG95 guidelines.
To generate the maximum effect lasers are best used in conjunction with
•
haze machines.
The front panel of this unit has a blue LED to indicate when it is active and
•
detecting sound – if the sound ceases to be detected the unit will enter
standby after 8 seconds.
Trouble Shooting:
Fault Description
No laser output
If the unit is not responding
•
If the Power Supply indicator light is illuminated indicating the mains supply is
•
present and the unit does not respond check the
Suggested Solution
Check the power supply indicator on the front
panel, if this is not lit firstly check the unit is
powered up and connected to a live mains outlet.
Check the mains On/Off switch and the safety Key
Switch override.
The lasers are protected by a fuse in the 13A-IEC
cord and also one on the mains input IEC
connector. Both fuses should be replaced by the
same type and value.
The lasers are sound activated – if the sound level
is too low or the unit is on minimum sensitivity the
unit may enter standby mode. Either increase the
sensitivity or turn up the sound level. Care should
always be taken when using PA systems etc as high
SPL's can present a danger to your hearing.
Assuming all of the above have been checked and
the unit is still unresponsive please return the unit
to the retailer from whom you originally purchased
the unit.
10
Advertisement
Table of Contents
