Lubrication Recommendations; Start Interlock System - Polaris BRUTUS Owner's Manual For Maintenance And Safety

Lubrication Recommendations

Check and lubricate all components at the intervals outlined in the Periodic Maintenance
Chart beginning on page 73, or more often under severe use, such as wet or dusty conditions.
Items not listed in the chart should be lubricated at the general lubrication interval.
Item
Engine Oil
Brake Fluid
Main Gearcase Oil
(Transmission)
Front Gearcase Oil
Front Prop Shaft Yoke
and PTO shaft
Front and rear
suspension

Start Interlock System

The utility vehicle is equipped with a Start Interlock
System. The following must be in place before the
Utility Vehicle can be started:
• The gear selector lever must be in Park, Neutral, or
the treadle pedal must be in neutral
• PTO must be OFF (If Equipped)
Inspection
To check the function of the Start Interlock System,
preform this procedure in an open area on flat level
ground and make sure the area is clear of bystanders.
1. With the gear selector lever in low gear and the
PTO OFF, move the treadle pedal to the forward
travel position, the engine must not start. Repeat
the procedure with the gear selector in High and
moving the treadle pedal into the reverse direction.
2. With the treadle pedal in neutral and the gear
selector lever in PARK, move the PTO to the ON
position, the engine must not start.
3. If the engine starts in any of these positions, see
your dealer for service.
Lube
See page 82-83
DOT 4 Brake Fluid
AGL Gearcase Lubricant &
Transmission Fluid
Demand Drive Fluid
U-Joint Grease
U-Joint Grease
MAINTENANCE
Method
Maintain level between fill lines. See page 96.
See page 84.
See page 85.
Locate fittings and grease (3 pumps maximum).
See page 114.
Locate fittings and grease (3 pumps maximum).
See page 114.
Control Pedal
Lever
PTO
79