Samsung SyncMaster 710T User Manual page 44

Before calling for service, check the information in this section to see if you can remedy any
problems yourself. If you do need assistance, please call,
section or contact your
Symptom
No images on the
screen. I cannot turn
on the monitor.
Downloaded from ManualMonitor.com Manuals
SyncMaster 510T / 710T / 910T
dealer.
Check List
Is the power cord connected properly?
Can you see "Check Signal Cable" on
the screen?
If the power is on, reboot the computer
to see the initial screen(the login
screen), which can be seen.
Can you see "Not Optimum Mode"
"Recommended mode 1280 x 1024
60Hz" on the screen?
the phone number on the Information
Solutions
Check the power cord connection and
supply.
(Connected using the D-sub cable)
Check the signal cable connection.
(Connected using the DVI cable)
If you still see an (error) message on
the screen when the monitor is
connected properly, check to see if the
monitor status is set to analog.
Press Source button to have the
monitor double-check the input signal
source.
If the initial screen (the login screen)
appears, boot the computer in the
applicable mode (the safe mode for
Windows ME/XP/2000) and then
change the frequency of the video
card.
(Refer to the Preset Display
Note: If the initial screen (the login
screen) does not appear, contact a
service center or your dealer.
You can see this message when the
signal from the video card exceeds the
maximum resolution and frequency
that the monitor can properly handle.
Adjust the maximum resolution and
frequency that the monitor can
properly handle.
If the display exceeds SXGA or 75Hz, a
"Not Optimum Mode.
Recommended mode 1280 x 1024
60Hz" message is displayed. If the
display exceeds 85Hz, the display will
work properly but the "Not Optimum
Mode. Recommended mode 1280
Modes)