Charcoal Embers (Optional); Vermiculite (Optional); Glowing Embers (Optional); Logo Placement - Napoleon Castlemore GDS26N Installation And Operating Instructions Manual

Place the center log as shown, follow contour
6.3.3
of burner and ensure port holes are not
covered.
6.4

CHARCOAL EMBERS (OPTIONAL)

Randomly place the charcoal embers along the front and sides of the log support tray in a realistic manner.
Fine dust found in the bottom of the bag should not be used.
NOTE: Charcoal embers are not to be placed on the burner.
6.5

VERMICULITE (OPTIONAL)

Sprinkle vermiculite around the charcoal embers.
NOTE: Vermiculite is not to be placed on the burner.
6.6

GLOWING EMBERS (OPTIONAL)

Tear the embers into pieces and place along the burner ports covering all of the burner. Care should be taken
to shred the embers into thin, small irregular pieces as only the exposed edges of the fi bre hairs will glow. The
ember material will only glow when exposed to direct fl ame; however, care should be taken to not block the
burner ports.
Blocked burner ports can cause an incorrect fl ame pattern, carbon deposits and delayed ignition. Phazer
logs glow when exposed to direct fl ame. Use only certifi ed "glowing embers" and Phazer
your Napoleon® dealer.
6.7

LOGO PLACEMENT

Remove the backing from the logo and position onto the
control door as shown.
Place the hole in the underside of the right log
6.3.4
onto the locating pin, on the burner base and
rests against the rear log as shown.
Re-install the glass door.
6.3.5
1/2"
1/2"
LOGO
35
32.1
33.1
TM
logs available from
TM
W415-0827 / A / 06.07.10