Rear Vent Conversion - Napoleon Castlemore GDS26N Installation And Operating Instructions Manual

22

3.12 REAR VENT CONVERSION

In order to convert the venting confi guration from a top exit to a rear exit, remove components as illustrated:
When reinstalling in the alternate position: Check gaskets for tears, replace if necessary to ensure a proper
seal.
Outer Top
7" Collar
7" Gasket
4" Collar
4" Gasket
W415-0827 / A / 06.07.10
2
3
4
5
8
6
7
4" Cover
Plate
4" Gasket
- Remove the rear shield and the knockout.
- Remove the outer top.
- Replace components 3 through 6 onto the rear of
appliance.
- Replace components 7 through 10 onto the top of
appliance.
- Before replacing rear shield, slide the vent pipe through
the rear shield a few inches, secure 4" and 7" to the collars.
- Slide the rear shield along the vent pipe and re-secure to
the appliance.
- Complete vent installation.
10
9
7" Cover
Plate
7" Gasket
Knockout
1
Rear Shield