Safety & Cautions - Ioline I/S 60 Quick Start Manual

Please read these safety guidelines before beginning operation of
the cutter. The cutter uses a very sharp blade when cutting. The
parts can move quickly. Always observe the following safety pre-
cautions:
n Do not allow the material to become suddenly taut between
the cutter and a roll of material during plotting. A service
loop of unrolled material is required for problem-free opera-
tion. Using the Autoloop function (enabled in the Control
Center) will create the required service loop by gently pulling
a set amount of material from the roll before cutting. Ioline
recommends using the Autoloop function when plotting on a
roll of material.
Do not try to repair the machine without factory authorization.
n
Only qualified service personnel should attempt any disas-
sembly or access to internal components. If external mechanical
adjustments are necessary, turn off the cutter and disconnect it
from all power sources (both the computer and the wall outlet).
n Be careful with hair, jewelry, or loose clothing near the cutter.
They can become caught in the mechanical parts.
Never move the carriage by hand. Use the Arrow keys and let
n
the machine do it.
n Keep hands away from the carriage when the cutter is in opera-
tion. The carriage will automatically move to its right end posi-
tion when the power is turned on.
Be careful when lifting the cutter. Hold the bottom surfaces of
n
the cutter to lift or move it.
n Keep fingers away from the drive shaft when the cutter is in
operation.
Use caution when changing a blade in the blade holder. See the
n
Routine Maintenance chapter of the SmarTrac User Guide for the
recommended procedure.
Be careful when handling the blades. They are sharp and could
n
cause an injury if mishandled. Although the blades are made
of an extremely hard material, they are brittle and can break if
dropped or mishandled.
Safety &
Cautions