A&D UA-651BLE Instruction Manual page 13

USING THE MONITOR
Pairing procedure
1. Follow the instructions in the manual of the receiver device to switch it
to the pairable status. When pairing this monitor, place it as close as
possible to the receiver device to be paired with.
2. Install the batteries or connect the AC adapter.
Press and hold the "START" button until "Pr" is displayed,
then release the button.
The monitor will be in a state that can be found by the
receiver device for about one minute.
3. The monitor displays "End" to indicate that pairing is
complete.
4. If "Err 10" is displayed or pairing is failed, remove the
batteries or disconnect the AC adapter and try steps 1-3 again.
5. Follow the manual of the pairing receiver device to search for, select
and pair with this monitor.
Communication distance
The communication distance between this monitor and the receiver
device is about 33 feet (10 m). This distance is reduced by the conditions
in the surrounding environment, so be sure to check that the distance is
short enough for a connection to be made after measurement is complete.
E-12
A&D Medical (Toll-Free): 1-888-726-9966