Hardware Output Diagnostic Test Mode - Fisher & Paykel DD603 User Manual

Hardware Output Diagnostic Test Mode

This level tests all the hardware outputs and inputs. The LCD display shows
"HO".
Press POWER to skip hardware diagnostics and advance to the next level.
Press START/PAUSE to enter hardware diagnostics.
Once hardware diagnostics has been entered, the current hardware output
being tested is indicated by letters in the LCD display, and for integrated
models the LEDs on the touch switch panel using binary encoding, as shown
in the table on the next page.
Different combinations of outputs can be switched on or off together, but the
controller will prevent higher current drawing components such as the wash
pump and the lid motors being turned on together.
Press START/PAUSE to advance to the next hardware output.
Press KEYLOCK to turn the currently displayed output on or off. If the
scrubbing brush symbol (green LED above start/pause button on integrated
models) is displayed, then that output has been switched on, and if it is not
displayed then that output is off.
Press POWER to Exit at any time (all outputs will be switched off on exit).
9