Fisher & Paykel DD603 User Manual page 10

As mentioned on the previous page, the LCD display and touch switch panel
LEDs are illuminated to correspond to a particular hardware device. The
following table details the display order of the test.
Norm Fast
LCD LED LED
bL Off
Er Off
Ld Off
dd Off
FU Off
P1 Off
P2 Off
rd On
dF On
LE On
C1 On
C2 On
On
°C
On
°E
(C3 is used in the Factory to empty the Water Softener before the Product is
packed.)
WARNING: In diagnostic mode there is no component protection. Therefore
take care when running individual components not to overload them. It is
advisable to avoid turning the element on without filling the tub with water first.
NB : No fault codes will come up while in diagnostics mode.
Tub Home Sensor Test: At any time during HO test mode, the Keylock
symbol on the LCD display (Keylock LED on integrated badge) indicates the
tub position. On = Closed, Off = Open.
Deli Rinse
LED LED
Off Off On
Off On Off
Off On On
On Off Off
On Off On
On On Off
On On On
Off Off Off
Off Off On
Off On Off
Off On On
On Off Off
On Off On
On On Off
Hardware Output
Backlight
Element Relay
Lid Motors (will run for 10 seconds)
Detergent Diverter Valve
Fill Water Valve
Motor Wash direction (2300-2850
rpm)
Motor Drain direction (4200 rpm)
Rinse Aid Dispenser (dispenses
current setting)
Drying fan
Rinse Aid LED
Water Softener Diverter Valve
Water Softener Brine Pump
Displays current water temperature.
Displays controller rail voltage
10