MOTION DETECTION SETUP
The recorder allows the user to adjust several different Motion Settings and create motion detection areas.
Set up advanced
motion area
Create a Motion Area
1.
On the Display screen, click Setup.
2.
Click Motion Detection.
3.
Select a camera from the Select Channel list.
4.
Select Detect Detail Motion Area.
5.
Click Clear Motion Area.
6.
Click Setup Advanced Motion Area.
7.
Click a Motion Detection Area shape button.
8.
Drag the mouse over the camera image.
Note To create a polygon shape, click the mouse at each point and double-click to close
the shape.
9.
Click OK.
10. Move the sliders to adjust motion sensitivity and the noise filter.
11. Define the pre-alarm and post-alarm recording time for a motion event.
Pre Alarm Recording – 0 - 120 Seconds [The number of seconds the recorder records before motion is detected—to ensure any motion
occurring between I-frames is captured, set to a value greater than 0]
Post Alarm Recording – 0 - 120 Seconds [The number of seconds the recorder records after it stops detecting motion]
32338AC
Set post-alarm recording and sensor
duration
Set pre-
alarm
recording
duration
27