Dtc P0010: Vtc Oil Control Solenoid Valve Malfunction - Acura TSX 2004 Manual

DTC P0340
DTC P0341
DTC P0344
DTC P2646
DTC P2647
DTC P2648
DTC P2649

DTC P0010: VTC OIL CONTROL SOLENOID VALVE MALFUNCTION

1. Turn the ignition switch ON (II).
2. Clear the DTC with the HDS.
3. Start the engine. Hold the engine speed at 3,000 RPM with no load (in Park or neutral) until the radiator
fan comes on, then let it idle.
4. Do the VTC TEST in the INSPECTION MENU with the HDS.
5. Check for Temporary DTCs or DTCs in the DTCs MENU with the HDS.
Is DTC P0010 indicated?
YES: Go to step 6.
NO: Intermittent failure, system is OK at this time. Check for poor connections or loose
terminals at the VTC oil control solenoid valve and the ECM/PCM.
6. Turn the ignition switch OFF.
7. Disconnect the VTC oil control solenoid valve 2P connector.
8. Measure resistance between VTC oil control solenoid valve 2P connector terminals No. 1 and No. 2.
Is there 6.75-8.25 ohm?
YES: Go to step 9.
NO: Go to step 15 .
Wednesday, March 12, 2008 2:17:58 AM
2004 Acura TSX
2004 ENGINE PERFORMANCE VTEC/VTC - TSX
CMP Sensor & CKP Sensor Incorrect Phase Detected
Page 2
CMP Sensor A No Signal
CMP Sensor A Intermittent Interruption
Oil Pressure Switch Circuit Low Voltage
VTEC Oil Pressure Switch Circuit High Voltage
VTEC Solenoid Valve Circuit Low Voltage
VTEC Solenoid Valve Circuit High Voltage