Operation - Zenoah LRT2300 Owner's Manual

8. Operation

STARTING ENGINE
IMPORTANT
1. Rest the unit on a flat, firm place. Keep the cutting
head off the ground and clear of surrounding objects
as it will start rotating upon starting of the engine.
2. Pump the primer until fuel flows out in the clear
tube.
3. Move the choke lever upward to close the choke.
4. Shift the ignition switch to the START position.
5. While pulling the throttle lever with the little finger of
your left hand, pull the starter rope briskly.
NOTE
• Avoid pulling the rope to its end or returning it by
releasing the knob. Such actions can cause starter
failures.
6. When the engine has started, move the choke lever
gradually downward to open the choke
7. Allow the engine to warm up for a half minute before
starting operation.
1. When restarting the engine immediately after stop-
2. Overchoking can make the engine hard to start due
STOPPING ENGINE
1. Release the throttle lever and run the engine for half
2. Shift the ignition switch to the STOP position.
• Except for an emergency, avoid stopping the engine
ADJUSTING THROTTLE CABLE
The normal play is 1 or 2 mm when measured at the
carburetor side end. Readjust with the cable adjuster
as required.
(1) Choke lever
(2) CLOSE
(3) OPEN
ADJUSTING IDLING SPEED
• When the engine tends to stop frequently at idling
(1) Ignition switch
(2) START
• Engine idling speed: It is normal that the engine
(3) STOP
• Warm up the engine before adjusting the idling
NOTE
ping it, leave the choke open.
to excess fuel. When the engine fails to start after
several attempts, open the choke and repeat pulling
the rope, or remove the spark plug and dry it.
minute.
NOTE
while pulling the throttle lever.
(2)
(1)
mode, turn the adjusting screw clockwise.
keeps running without the blade rotation, when the
throttle lever is released. When the engine speed is
too high or too slow, readjust the idle set screw.
NOTE
speed.
LRT2300
(1) Cable adjuster
(2) 0.04in (1~2mm)
(1) Idle adjustment screw
(2) Cable adjuster
GB-9
G
B