Carton Contents - Flymo Contour 500 XT Original Instructions Manual

Instruction
Manual
IMPORTANT ! Please check the contents of the carton are correct BEFORE assembling your new Flymo product.
IF ANY PARTS ARE MISSING CONTACT:-
Husqvarna UK Ltd. Customer Service Department direct
Telephone : 0844 844 4558 UK
WARNING. When using the product the safety rules must be followed. For your own safety and that of bystanders
please read these instructions before operating the product. Please keep the instructions safe for later use.
Explanation of Symbols on the product
Warning
Read the user instructions carefully to make
sure you understand all the controls and what
they do.
Keep bystanders away. Do not operate
10m
whilst people especially children or pets
are in the area.
General
1. This product is not intended for use by persons (including
children) with reduced physical, sensory or mental ca-
pabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning
the use of the product by a person responsible for their
safety. Children should be supervised to ensure that they do
not play with the product. Local regulations may restrict the
age of the operator.
2. Never allow children or people unfamiliar with the in-
structions to use the machine.
3. Stop using the machine while people, especially chil-
dren, or pets are nearby.
4. Only use the trimmer in the manner and for the func-
tions described in these instructions.
5. Never operate the trimmer when you are tired, ill or
under the influence of alcohol, drugs or medicine.
6. The operator or user is responsible for accidents or
hazards occurring to other people or their property.
Electrical
AVOID ACCIDENTAL STARTING. REMOVE PLUG FROM
MAINS AND KEEP FEET AWA Y FROM THE SWITCH LEVER
WHEN:- CLEANING AROUND THE INSIDE OF THE SAFETY
GUARD, REMOVING OR REFITTING SPOOL CAP ,
MANUALLY FEEDING OR REPLACING NYLON LINE.

Carton Contents

Switch Handle
Steady Handle
Tube
Trimmer Head
Wheel
1800 882 350 ROI
Safety
Electric Cable with
moulded on plug
Safety-
Guard
Plant and Tree Guard
Fax : 01325 302530
Wear eye protection
Do not operate in the rain or leave the product
outdoors while it is raining.
Switch off! Remove plug from mains before
adjusting, cleaning or if cable is entangled or
damaged.
Warning: The cutting line continues to rotate after the
machine has been switched off.
1. We recommend the use of a Residual Current Device
(R.C.D.) with a tripping current of not more than 30mA.
Even with a R.C.D. installed 100% safety cannot be guar-
anteed and safe working practice must be followed at all
times. Check your R.C.D . every time you use it.
2. Before use, examine cable for damage. If the cable is found
to be defective, take the product to an Authorised Service
Centre and have the cable replaced.
3. Do not use the trimmer if the electric cables are damaged or worn.
4. Immediately disconnect from the mains electricity supply if
the cable is cut, or the insulation is damaged. Do not touch
the electric cable until the electrical supply has been dis-
connected. Do not repair a cut or damaged cable. Re-
place it with a new one.
5. Your extension cable must be uncoiled, coiled cables
can overheat and reduce the efficiency of your trimmer.
6. Keep the cable clear of the cutting area and obstacles
at all times.
7. Do not pull cable around sharp objects.
8. Always switch off at the mains before disconnecting
any plug, cable connector or extension cable.
9. Never pull on the cable to disconnect any of the plugs.
10.Switch off, remove plug from mains and examine electric
supply cable for damage or ageing before winding cable for
storage. Do not repair a damaged cable, replace it with a