Installing Work Clamp; Installing Welding Gun - Miller Millermatic 210 Owner's Manual

4-6. Installing Work Clamp

Tools Needed:
3/4 in

4-7. Installing Welding Gun

OM-1325 Page 12
2 1
3
1
3
4
2
1 Work Cable
2 Boot
Route cable through front panel
opening. Slide boot onto work
cable.
3 Negative (−) Output Terminal
Connect cable to terminal and
cover connection with boot.
Close door.
Ref. 802 474-D
1 Drive Assembly
2 Gun Securing Knob
3 Gun End
Loosen securing knob. Insert gun
end through opening until it bottoms
against drive assembly (make sure
gun end does not touch drive rolls).
Tighten knob.
4 Gun Trigger Plug
Insert plug into receptacle, and
tighten threaded collar.
Close door.
Ref. 802 064-C