Self Check - Haier HW50-1010W Service Manual

SERVICE MANUL
HW50-1010W/HW50-1010S

9-2. Self check

Press "Strong Wash" button, and plug in, then the WM will be on self-inspection mode,
all the indication light will be on. Press start/pause button starts the Testing Program.
1.Door lock switch testing, if the door is unlooked, Failure alarm 1.
2.Water inlet for main wash valve 5S, Water inlet for prewash valve 5S, and hot water
inlet 5S, if it can't reach the 1st water level within 2 Mins, Failure alarm 5. 3．Heating
10 秒
3.Heat the water for 10 Secs.
6、Water drainage to empty cylinder water level, if it can't reach the empty cylinder
water level within 2 Mins, Failure alarm 2.
7．Spin speed to the Max RPM of this Model.
9．Unlock program finishes, all the indication light is off except the "stop" indication
light.
If it's necessary to stop the program during the testing, press the start/pause button or
makes power off; if there's failure alarm during the testing, pls deal with it according
to the Alarm Handling Methods.
9-3 Model selection
Press the "Speed" and "Strong wash" button, the machine will be on Model Selection
mode, the Buzzer beeps one time.
When it comes in the Model selection mode, the 55cm 6kg 1200 rpm model is set as
default, during the following time, all the indication light is on alternately, the light of
spin exclusion is on; the light of speed is all on. Press "speed" button, makes 5kg and
6kg switch over.
Speed indication
light status
all on
all off
X.2 The speed of the model can be adjustable bwtween
1250/1050/950/850/750/650/1350 under the condition that all the speed light is off,
while the speed can be adjustable between 1260/1060/960/860/760/660/1360 with all
the speed light on.
washing program indication
light
Light of spin exclusion on
light of wool wash on
light of synthetic 0 ℃ on
light of synthetic 30 ℃ on
light of quick wash on
Corresponding Model
6kg
5kg
Corresponding spin
speed
1350/1360
1250/1260
1050/1060
950/960
850/860
Front Load Washing Machine
２１