Table of Contents
Advertisement
Problem
Drying results unsatisfactory.
Loading door does not close.
Drying cycle ends shortly after pro-
gramme starts.
Drying cycle lasts an unusually long
time. Note: After around 5 hours the
drying cycle ends automatically.
1) Only dryers with conductance programming
2) Only dryers with removable filter
Machine settings
Setting
BUZZER permanent off
10
Possible cause
Wrong programme selected.
Fluff filter clogged.
Overloading of laundry.
Ventilation slots covered up.
Residue on inside surface of drum or
drum ribs.
Conductance of water at installation
site differs from standard setting of
1)
machine.
2)
Filter not in place
.
Not enough washing loaded or wash-
ing loaded is too dry for selected
programme.
Filter clogged.
Load volume too big.
Laundry insufficiently spun.
1.
Turn the programme selector to any programme.
2.
Press simultaneously the DELICATE and ANTI-CREASE buttons and hold
down for approx. 5 seconds.
3.
The buzzer is by default always off.
Select a different programme the next
time you dry (see "Programme chart"
chapter).
Clean fluff filter.
Observe recommended loading vol-
umes.
Uncover ventilation slots.
Clean inside surface of drum and
drum ribs.
Re-programme standard setting for
degree of drying (see 'Machine set-
tings' chapter)
Install filter into place
Select time programme or higher
drying level (e.g. EXTRA DRY instead
of CUPBOARD DRY ).
Clean filter.
Reduce load volume.
Laundry must be adequately spun.
Implementation
Remedy
1)
.
2)
.
Advertisement
Table of Contents
