Table of Contents
Advertisement
Basic operation setup menu
Access setup interface
Click on the main screen [Setup] icon,
enter the setting interface.
With a finger or touching pen to gently
sliding screen can be set about switching
interface.
Navigation setting
Navigation path has been set at the
factory, please do not enter the navigation
setup interface to change the path freely,
otherwise the procedure many lead to
abnormal navigation.
Video setting
In the set interface click [VIDEO] icon, into
the video set interface.
Brightness: Drag icon can adjust video
rJ
the screen brightness.
Forbid play on run: Driving ban and click
on
play icon can open/close the
function.
Audio setting
In the set interface click [AUDIO]
icon,
into the Audio set interface.
Click •
into sound effect default interface.
Press
into loudspeaker interface,
click
to adjust the channel of
loudspeaker, touch ....
•~
to get back to initial
.
T
sett1ng.
BEEP: click that icon to switch on/off that.
LOUD: click that icon to switch on/off that.
EQ: click that icon to switch different mode.
Time setting
Click the Settings interface Time setting
icon, enter the Time settings screen,
12h/24h interchangeable, as shown below:
In the year, month, day, hour, sub-office
slide up and down to the relevant settings.
Zone is set to enter the time zone settings
interface when clicked.
Choose the time zone, click
the~
icon
to save your settings and exit the time
setting interface.
Touch calibration
If touch calibration error occurs, you can
adjust the touch coordinate by "Touch
calibration". Click [CALIBRATION] icon on
setup interface, click OK to pop up a [Do
you want to calibration?] as shown below,
click OK to confirm to access touch
calibration interface:
Touching methods
Use touch pen to click the center of'+" icon,
and move along with center of
"+"
icon so
as to calibrate the screen, It shall
automatically save data and exit after
screen calibration. Please accurately click
all positions on screen, or the accuracy of
touch calibration shall be affected
.
SET COMM setting
In the set interface click [SET COMM]
icon,
into the Serial port set interface.
Choose good then click the
Ell
icon
to
save
your settings and exit the serial port
>ettings
interface.
14
Advertisement
Table of Contents
