Table Of Contents; Mount The Uns In A Rack - ZyXEL Communications UNS2300 Hardware Installation Manual

1.1 Overview
• Mount the UNS in a Rack on page 3
• Insert a Hard Drive on page 6
• About the Power Modules on page 8
• Make Rear Panel Connections on page 9
• Turn on the UNS on page 10
• Observe the LEDs on page 10
• Accessing the UNS on page 14
• Configure the UNS Using the Web Configurator on page 16

1.2 Mount the UNS in a Rack

Prepare the Installation Requirements
1
Separate the Slide Rails
2
Connect the Inner Rail to the UNS
3
Connect the Outer Rail to the Rack
4
Insert the UNS into the Rack
5
1.2.1 Prepare the Installation Requirements
• A rack with 2U space.
• Two sliding rails.
• 10 M6 screws for attaching both outer rails to the rack.
• The rack depth can be from 71.12 cm to 91.44 cm (28 to 36 inches).
Note: Failure to use the proper screws may damage the unit.
1.2.1.1 Precautions
• Make sure the rack will safely support the combined weight of all the equipment it contains. The
weight of the UNS with 12 hard drives installed is about 22.8 KG. The maximum load the rails can
hold is 33.56 Kg.
UNS Series Hardware Installation Guide
C
H A PT ER
Hardware Installation
1
3