Wire Connection Guide - Clarion NX404E Quick Start Manual

Installing the Main Unit in TOYOTA Vehicle
Install by using parts attached to the vehicle. (Screws marked
vehicle.)
Center Panel
(*1)
Figure 6
*1. Some panel openings are too small for the unit depending on the vehicle type and
model. In such a case, trim the upper and lower sides of the panel frame by about
0.5 to 1.5 mm so the unit can be inserted smoothly.
*2. If a hook on the installation bracket interferes with the unit, bend and flatten it with
a nipper or similar tool.
Typical Mounting Brackets
Example 1
Affix the screws to the
30 NX404E
are attached to the
Main Unit
8- Hexagonal
screws
(M5x8)
Mounting bracket
(1 pair for the left
(*2)
and right sides)
Example 2 Example 3
marks.

WIRE CONNECTION GUIDE

Note:
• Before installing, be sure to disconnect the negative cable of the car
battery.
• In the optional devices, the RCA cables and the Connector cables are
separately-sold items.
• When connect the HDMI cable, be sure to fix with the HDMI cable holder
and Machine screw (M2 x 4).
NX404E
Refer to
page 32
HDMI CABLE
Red Red White White White Red
Front Rear Front Rear
Right Right Left Left
4-Channel Amplifier
GPS
Antenna
DTX502E or DAB404E
HDMI cable holder
iPod/iPhone
Radio Antenna
iPod/iPhone
CCA-750(sold separately)
MIC
Red
AUX2 AUDIO IN RCH
White
AUX2 AUDIO IN LCH
Yellow
AUX2
VIDEO IN
White
REAR LCH
Red
Monitor
REAR RCH
For Rear zone
Yellow
VIDEO OUT
Yellow
CAMERA
Video Out
Rear Vision Camera