Hifonics Titan TXi4408 User Manual page 9

TXi1008D / TXi1508D / D CLASS 1 CHANNEL AMPLIFIER APPLICATIONS
Basic application
Interconnect cable checklist:
- Connect the line inputs to a Radio/CD RCA outputs or line output of the
full range primary amplifier with good quality RCA cables. A "Y" adapter
may be needed as shown in the diagram.
- Use at least #12 gauge speaker wiring. These amplifiers have dual
speaker terminals, simplifying the hookup of multiple speakers
Crossover frequency control checklist:
- LOW PASS: 35Hz to 250Hz
- SUBSONIC:15 Hz to 35 Hz
- BASS EQ: 0 to 10dB
- PHASE: 0 to 180 degrees
Level control checklist:
- Refer to the section "Setting up systems after installation for best
performance"
DESIGNATED
*
MONO LINE INPUT
STEREO LINE
OUTPUT
Dual Subwoofer Application
DESIGNATED
*
MONO LINE INPUT
STEREO LINE
OUTPUT
Minimum final loudspeaker impedance:
- 1 ohm.
FULL RANGE
STEREO LINE INPUT
NOT USED
Note: You can use the Radio/CD designated mono line output
*
or a full range stereo line output. For full range stereo line output,
you will need an optional "Y-Adaptor" as shown
Y-ADAPTOR
MONO
SUBWOOFER
TO BATTERY +12v
VIA FUSE
REMOTE TURN-ON
CHASSIS GROUND
PARALLEL MONO
SUBWOOFERS
2-OHMS EACH MINIMUM
MONO
SUBWOOFERS
TO BATTERY +12v
VIA FUSE
REMOTE TURN-ON
CHASSIS GROUND