Table 6 Series 610 Terminal Commands - Liebert 610 Series Operation & Maintenance Manual

Remote Monitor Panel
The Liebert Remote Monitor Panel provides an LED indication of the following conditions:
• Load On UPS
• Load On Bypass
• Battery Discharge
• Low Battery Warning
• Overload
• Ambient Overtemp
• System Summary Alarm
• New Alarm
This information is also available for customer use through a set of contacts on a separate terminal
board.
Alarm messages that activate the System Summary Alarm are listed in Table 1 and Table 2.
The Remote Monitor Panel housing is a NEMA Type 1 enclosure, available for either surface-mount
or flush-mount installations.
Separate / Simultaneous Outputs
The RS-232 interface can support a modem plus either a local terminal or a local monitor. The
SiteScan port can support either SiteScan or SNMP communications. Whatever communication
options are installed in the Series 610 UPS can all be used simultaneously.
Table 6 Series 610 terminal commands
Key(s)
A, return
^B (control-B), return
C, return
F (no return)
G, return
Q (no return)
d mm/dd/yy, return
t hh:mm:ss, return
H, return
I, return
J, return
K, return
L, return
M, return
N, return
backspace
Displays Present Status Report screen.
Displays Event History Report screen, starting with the most recent frame and then
scrolling back through earlier frames.
Displays History Status Report screen starting with the most recent frame and then
scrolling back through the earlier frames.
Freezes data output. This stops the data scrolling on the monitor to allow closer study or a
printout. This is a toggle switch command. Press the "F" key again to resume data scrolling.
Resets (unfreezes and clears) the History Status Report memory buffer. This erases the
alarm messages and meter indications that were stored immediately before and after a
significant system fault. NOTE: Do not reset the History Status Report memory buffer until
operation and maintenance personnel have reviewed it as a troubleshooting tool.
The data output stops (quits). The UPS communication system remains on stand-by, ready
to receive the next communication command. NOTE: To return to the beginning of the
Event History or History Status Report, press Q, then request your desired report again.
This entry sets the date (month/day/year) in the UPS system clock. You must include the
slash (/) as you key in the date. Note that the d command must be lower case.
This entry sets the time (hour:minute:second) in the UPS system clock. You must include
the colon (:) as you key in the time. Note that the t command must be lower case.
Prompts the UPS system to hang up its modem (only applicable to the modem
communications port).
Display Battery Cycle Monitor information for 0-30 second discharge events.
Display Battery Cycle Monitor information for 31-90 second discharge events.
Display Battery Cycle Monitor information for 91-240 second discharge events.
Display Battery Cycle Monitor information for over 240 second discharge events.
Display Status Summary screen of battery discharge events.
Show detail information on all battery discharge events in order of occurrence (last in, first
out).
Moves cursor left to cancel previous entry or command.
Function
57
Operation